Woodstock SHOP FOX W1758 Spezifikationen PDF herunterladen (Seite 33)

-31-

W1758 Owner's Manual (Mfg. Since 3/10)



  

Bad surface finish. 1. Wrong spindle speed.

2. Dull chisel or wrong chisel being

used for operation.

1. Use trail-and-error to find better spindle speed.

2. Sharpen chisel or try a different chisel.

Tailstock moves. 1. Tailstock mounting bolt loose.

2. Bed surface is oily or greasy.

1. Tighten.

2. Clean bed surface to remove excess oil/grease.

Excessive vibration. 1. Workpiece mounted incorrectly.

2. Workpiece warped, out of round,

or is flawed.

3. Spindle speed is set too fast for

mounted workpiece.

4. Lathe is resting on uneven surface.

5. Motor mounting bolts are loose.

6. V-belt is worn or damaged.

7. Spindle bearing(s) are worn.

1. Re-mount workpiece, making sure centers are

aligned and are fully embedded in true center of

workpiece.

2. Cut workpiece to correct, or use a different

workpiece.

3. Reduce spindle speed.

4. Shim legs or adjust machine feet to ensure lathe is

even and stable on the floor.

5. Tighten motor mounting bolts.

6. Replace V-belt (refer to ).

7. Replace spindle bearing(s).

Chisels grab or dig into

workpiece.

1. Tool rest adjusted too low.

2. Tool rest set too far from

workpiece.

3. Wrong chisel/tool being used.

4. Chisel/tool is dull.

1. Adjust tool rest higher (refer to ).

2. Move tool rest closer to workpiece (refer to 

).

3. Use correct chisel/tool; educate yourself by read-

ing books, trade magazines, or seeking help from

an experienced lathe operator.

4. Sharpen or replace chisel/tool being used.

Inaccurate turning results

from one end of the

workpiece to the other.

1. Headstock and tailstock are not

properly aligned with one another.

1. Re-align headstock and tailstock to one another

(refer to ).

Cannot remove tapered

tool from tailstock barrel.

1. Tailstock quill not fully retracted

into tailstock.

2. Debris or oily substance not

removed from quill and tapered

tool mating surfaces before

installing.

1. Turn quill handwheel until it forces tapered tool

out of quill.

2. Always make sure the mating surfaces of the quill

and tapered tool are free from debris and oily sub-

stances.



1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Woodstock SHOP FOX W1758 Spezifikationen Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drehmaschinen Woodstock SHOP FOX W1758