Woodstock SHOP FOX W1758 Spezifikationen PDF herunterladen (Seite 24)

-22-

W1758 Owner's Manual (Mfg. Since 3/10)





Spindle turning is the operation performed when a

workpiece is mounted between the headstock and

tailstock centers (see ).

 Typical spindle turning

operation.

Workpiece

Center

Pencil Lines

Marked

Diagonally

Across Corners

 Workpiece marked diagonally

from corner to corner to determine the

center.





Aligning Headstock & Tailstock

CentersPage 28









 Find the center point of both ends of your workpiece

by drawing diagonal lines from corner to corner

across the end of the workpiece (see ).

 Using a wood mallet, tap the point of the spur cen-

ter into the center of the workpiece on both ends,

leaving an indented center mark.

 Use a

⁄4" drill bit to drill a

⁄4" deep hole at the

center mark on the workpiece end to be mounted on

the headstock spur center.

 To help embed the spur center into the workpiece,

cut

⁄8" deep saw kerfs into the same workpiece end

along the diagonal lines marked in .

 If your workpiece is over 2" x 2", cut the corners off

the workpiece length-wise to make turning the cor-

ners safer and easier.

 Drive the spur center into the workpiece end center

mark with a wood mallet to embed it at least

⁄4"

into the workpiece (see ).

 With the workpiece still attached, insert the spur

center into the headstock spindle (refer to 

 on  for instructions).

Spindle Turning

 Spur center properly

embedded.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Woodstock SHOP FOX W1758 Spezifikationen Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drehmaschinen Woodstock SHOP FOX W1758